Quantcast
Channel: Automotive Repair Manual Download and Reviews » Search Results » how to remove wire harness ebcm on cavalier
Viewing all articles
Browse latest Browse all 10

2010 Honda CR-V Fog Lights Installation – Page 2

0
0

Honda CR-V Fog Lights Installation – Routing the fog light harness :

fog light harness13. Route the fog lights harness 1-pin connector in entrance of the left front interior fender as shown. Plug the fog gentle harness 1-pin connector to the vehicle 1-pin connector.
14. Secure the fog gentle harness to the car harness with two wire ties. Do not safe the fog gentle harness to the SRS harness.
15. Remove the automobile floor bolt, and secure the fog light harness ground terminal to the car floor terminal with the car floor bolt just removed.
16. Secure the fog lights harness to the car harness with two wire ties.
17. Route the fog gentle harness underneath the left headlight, and secure the fog mild harness clip to the automobile panel.
18. Secure the other two fog mild harness clips to the holes in the resonator.
19. Secure the fog light harness to the entrance bulkhead. With a Vehicle Harness: Minimize the clips off of the 2 wire ties with clips. Secure the fog lights harness to the car harness close to the harness clips using two wire ties. With out a Automobile Harness: Secure the fog light harness to the bumper beam utilizing two wire ties with clip and one wire tie.
20. Route the fog gentle harness under the bumper beam in the direction of the precise aspect of the vehicle. Secure the fog light harness. With a Automobile Harness: Lower the wire ties off of the 2 wire ties with clip. Safe the fog gentle harness to the vehicle harness using three wire ties. Without a Vehicle Harness: Secure the fog gentle harness to the bumper beam utilizing two wire ties with clip and one wire tie.
21. Utilizing isopropyl alcohol on a shop towel, clear the bumper beam surface where the harness tape will attach.
22. Proceed routing the fog gentle harness along the bumper beam to the suitable aspect of the vehicle. Safe the fog mild harness beneath the bumper beam utilizing two adhesive tapes and two wire ties linked together.
23. Route the fog light harness as proven, and safe the clip on the fog harness to the vehicle panel.
24. Safe 4 remaining fog mild harness clips to the holes in the automobile panel.
25. Reinstall the interior fender. With the assistance of an assistant, deliver the entrance bumper near the car, and plug the fog mild harness 2-pin connectors into the proper and left fog lights. Reinstall the entrance bumper.

Page 1 | Page 2 | Page 3 | Page 4


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images